Rental LED display

Go Back

Flexible series (full color,indoor and outdoor application, IP65)

Model:P20

Category:Rental LED display

Light Source:LED

Features:

 
 

Model SMD
(3 in 1)
pixel density
(dots/m²)
size of
cabinet(mm)
brightness
(cd/m²)
power consumption
(W/m²)

P20

5050

2500

320*1280

≥6500

768(Max.)
384(Avg)

Structure

Module unit

(MM:1280*320*31 Weight:4.54kg)

Introduction

 

Mechanical Specifications 

Electrical Specifications

Pixel Pitch:        

20mm 

LED Type:   

 LEDMAN SMD 3 in 1

Section Resolution: 

16*64,1024 pixel per Links 

Led Quantity:  

1024

Brightness:            

6000CD/sqm  

Led Lifetime:    

100,000 hours estimated

Viewing Angle:    

136°Vertical 136°Horizontal

Power input:

Manually Switchable 110V/ 220V

IP Rating:             0;

 IP65  

Power output:   

DC 24V

Transparency:     

 45%  

Power Consumption: 

180 Watts

Connection:          

 

ODU 5 pin signal connection
ODU 2 pin power connection 

Operating temperature: 

-10°C--45°C  
 

Operating Humidity::

 <70%
Weight/Dimensions  

Refresh Rate:       

>300Hz

In:50.39"*12.60"*1.22"
MM:1280*320*31   
Weight:4.54kg

Grey Level:    

  65536 levels

 

 

 

 

Installation

1. The connection between Hang Bar andMain Frame.
The Hang Bar is made of catch, aluminum rectangle hollow section joints, triangle hanger. Adjust the triangle hangers in the aluminum rectangle hollow section joints right for modules' width then fasten in screws like the showing in the picture 1; Catch can fit the aluminum rectangle hollow section joints perfectly if the rectangle hollow section joints' diameter is 50mm,and then fasten them well by screws like the showing in the following picture 2.

Picture 1

Picture 2

2. The connection betweenmodules and Hang Bar
The triangle and modules need to be connected and fastened by the screws which is made of stainless steel and its diameter is 3mm.The following pictures show the details.
3. The connections between modules
It is fast fastening links that link modules and keep the screen connect well in horizontal direction, under the
suggestion the fast fastening links need to connect the chains' two sides holes from up to down and fasten the modules well by the end of gourd design like the following pictures showed.
4. The installation of Power supply& sub-controller.
The Power sub-controller box need be installed behind the screen by steel cable hanging the two holes, the catches help the steel wire from slipping. The virtual effect picture of installation listed in below
 

5.Installation finished

Application

Details
Project performance